Topview Programmer A 1.0

The Topview Programmer A is an add-on card to the standard personal computer through the serial port.
The Topview Programmer A maintains separate buffer areas for selected device’s flash memory, Program Encryption Table, User parameter Table, Serial EEPROM in the programming environment. Initially you need to transfer your target program code/data from the files into this buffer and then program the selected device with these buffer contents.

When you keep your program code in the flash buffer, you can edit, modify them as per your requirement. Even you can visualize the buffer contents as the lines of program. This facility enables you to incorporate small modifications without taking the code to the original development tools.

The Programmer also supports programming flash memory using ICP and ISP modes. You can program the target device even after soldering the same in the target hardware.

Features of the programmer:

Supports more than 75 popular and widely available Philips Microcontrollers.
Also supports around 100 EEPROM devices from both Atmel and Microchip.
Single 40pin ZIF socket to accommodate DIP devices.
Devices with operating voltages 3.3V and 5V can be programmed.
Facility also available to program through ICP (for LPC9XX series) and ISP mode after soldering the device in the target board using a 10pin cable. This cable is madeavailable along with the programmer.
Verification at various voltages can be done as per Philips specification.
Programmer can be upgraded to support new devices at your premises.
LED indicators are provided for Power and Busy status.
Programmer can be connected through serial port of the personal computer.
The programmer is mounted in a sleek and eye catching wooden jewel box.
Programmer comes with a separate power supply and serial port cable and also ICP/ISP programming cable.

Programming Features:

Supports both Binary and Hex formats.
Commands and functions as per Philips specification.
Major Commands are:
Erase.
Blank Check.
Protect the Device against copying.
Read the Device signature.
Read the Protection status.
Device Configuration.
Program Status Byte and Boot Vector.
Program Flash Area.
Program Encryption Table.
Program User Parameter Table.
Verify.
Cycle Redundancy Check.
Auto Programming mode to automate the selected commands.
Multiple Devices can be programmed.
Project management facility.
Verification at various voltages as per your choice.
You can read the flash memory contents as the program.
You can edit and assemble and modify your application code.
Facility to program EEPROM families, 24XX, 25XX and 93XX from Atmel and Microchip.